Resin 3D Printer Flex Building Plate for Elegoo Saturn S 3D Printer 202 x 128 mm

Resin 3D Printer Spring Steel Flexible Build Plate and Magnetic Base Platform

Installation Notes:

1.Please clean your build plate thoroughly, let it dry.

2.Please connect your magnet to the plate, let it sit for a couple of hours（More than 24 hours is better）so it is fully seated.

3.Please install the spring steel plate on the magnetic base

4.Please reset the printer's leveling settings to start printing

Skills in use:

1.When installing the soft magnetic sheet, it is necessary to ensure that the printing platform is clean and dry. After installation, it is best to keep it in an inverted state, or it can be fixed with a clamp to ensure that the soft magnetic sheet is fully attached to the printing platform.

2.Please ensure spring steel is completely aligned with the magnetic base to avoid the resin entering the gap during use, which will affect the magnetic force of the soft magnet and cause the spring steel plate to fall off.

3.If there are burrs on the surface of the spring steel, please use sandpaper carefully to make sure that there are no burrs before using it to prevent the burrs on the spring steel from piercing the FEP film during the printing process.

4.After printing, do not excessively bend the spring steel when removing the model. After use, use alcohol or cleaning fluid to remove the residual resin on the surface.

5.After using for a period of time, if the model falls off the spring steel sheet during the printing process, you can sand the spring steel sheet with sandpaper to ensure that it has sufficient adhesion.

3D printing platform

It is necessary to ensure that the printing

platform is clean and dry. After installation, it

is best to keep it in an inverted state, or it can

be fixed with a clip to ensure that the soft

magnetic sheet is completely attached to the

printing platform.

Soft magnetic board

To prevent resin from entering the gap during

use, first ensure that the spring steel and the

magnetic base are completely aligned, so as

not to affect the soft magnetic force and cause

the spring steel to fall off during use.

Steel board

After the soft magnet is connected to the board, it is recommended to leave it for a few hours (more than 12 hours is better) to make it completely fixed.

window.adminAccountId=2667720232;