ENERGETIC Double Sided Textured And Smooth PEI Magnetic Spring Steel Sheet Heat Bed For Prusa i3 Mk3 Ender-3 CR10 3D Printer

ENERGETIC New Double-sided Textured and Smooth PEI Powder-coated Spring Steel Sheet Heat bed for Prusa i3 Mk3 3D Printer

Advantage:

1.Special Design:Double Sided Textured + Smooth PEI Sheet,One side textured, one side smooth, two kinds of surface to meet your different printing needs,Good Adhesion to the PEI surface, easy to remove the prints, flex slightly to pop your print right off.

2.Good Quality:Magnetic, Flexible, Removable Steel Flex PEI Plate,It can stick to magnetics very well. High strength and heat resistance.

3.Easy to Install:PEI spring steel sheet is flat and flexible, it comes without magnetic base, but could be magnetically attracted to the hotbed,(pls note you can use your magnetic base )

4.Easy to Clean:PEI 3d printer bed adhesive use a soft cloth to clean the dust. Gently wipe the stain with low concentration of alcohol.

Important Information:

1.Recommend print temps

• PLA – 60C

• HTPLA – 60C

• PETG – 70-80C

• PCTG – 70-80C

• ABS – 100C

2.Product Usage Guidelines

• PETG/PCTG/TPU– If you are not careful with your 1st layer you can risk bonding the PETG/PCTG/TPU to the PEI surface. This will damage the surface. To prevent damage to the surface apply hairspray or PVA gluestick before printing PETG/PCTG/TPU on the PEI

• Part Removal– Make sure your plate is at close to room temp (under 30C) before removing parts. If you remove when hot it more likely to damage the surface

Packing list

Double Side Textured and Smooth PEI *1

Please tear off Smooth PEI surface’s Protective film before using it.

ENERGETIC Double-Sided PEI Sheet

Textured PEI side

(Refined the powder coated PEI side.)

Smooth PEI side

(the smooth pei film is 0.2mm thick,and it is with 3m 468MP tape )

Textured PEI vs Smooth PEI – Which one looks better?

Happy Printing!!!